Step 7 - Inspect Integration Relay Circuit

1. Disconnect the connector from the integration relay and inspect the connector on the wire harness side, as shown in Fig 2.
   Fig 1: Identifying Integration Relay Circuit Terminals (Wire Harness Side)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   Fig 2: Integration Relay Circuit Terminal Specifications

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the connector from integration relay and remove the front cover on the junction block, as shown.
   Fig 3: Identifying Drivers Side Junction Block Integration Relay Circuit Related Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   Fig 4: Drivers Side Junction Block Terminal Specifications For Integration Relay Circuit

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If continuity is not as specified, replace the driver side junction block.