Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2002 >> Tacoma Base, 4D Pickup >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Systems - Diagnostics >> Circuit Inspection >> Drive Buckle Switch Circuit >> Inspection Procedure

Inspection Procedure

NOTE: In case of using a hand-held tester, start the inspection from step 1, and in case of not using a hand-held tester, start it from step 2.
  1. Check driver buckle switch using hand-held tester. 

    PREPARATION: 

    Connect a hand-held tester to the DLC 3.

    CHECK: 

    Check the driver buckle switch, using DATA LIST.

    1. OK: Proceed to next circuit inspection shown on problem symptoms table. See  PROBLEM SYMPTOMS TABLES  . 
    2. NG: GO TO NEXT STEP. 

  2. Check driver buckle switch. See  INSPECTION  . 
    1. NG: Replace faulty driver buckle switch. 
    2. OK: GO TO NEXT STEP. 
  3. Check wire harness and connector between driver buckle switch and body ground. 
    1. NG: Repair or replace wire harness or connector. 
    2. OK: Proceed to next circuit inspection shown on problem symptoms table. See  PROBLEM SYMPTOMS TABLES  . 
scientia non olet · About Mike's Workshop Manuals