Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 2001 >> Sienna LE >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Systems >> System Tests >> Test No. 20: Power Door Lock System Does Not Operate On Any Door

Test No. 20: Power Door Lock System Does Not Operate On Any Door

  1. Check DOOR fuse (25-amp) and GAUGE fuse (10-amp). These fuses are located in the fuse/relay box at driver's side of instrument panel. See Figure. If fuses are okay, go to next step. If any fuse is defective, replace fuse and repair wiring harness or electrical connector on wiring circuit as necessary. See WIRING DIAGRAMS . For additional wiring for power supply circuit, see POWER DISTRIBUTION article in WIRING DIAGRAMS.
  2. Check body Electronic Control Unit (ECU) for proper voltage and input signals. See BODY ELECTRONIC CONTROL UNIT  under PIN VOLTAGE TESTS. If proper voltage and input signals exist, go to next step. If proper voltage and input signals do not exist, repair as necessary and recheck power door lock system operation.
  3. Replace body ECU with a known-good body ECU and recheck power door lock system operation. If power door lock system operates properly, original body ECU was defective. If power door lock system still does not operate properly, check wiring harness and electrical connectors for body ECU and power door lock system for an intermittent problem. See WIRING DIAGRAMS in POWER DOOR LOCKS - TRUCKS (EXCEPT SEQUOIA) article. Body ECU may also be referred to as integration relay. Repair wiring harness or electrical connector as necessary.
scientia non olet · About Mike's Workshop Manuals