Section 12 (Engine Controls - Basic Diagnostic Procedures - V6 & V8): Introduction
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2000 Toyota Tundra, 2000 Toyota Tacoma, 2000 Toyota Sienna, 2000 Toyota Land Cruiser, and 2000 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
The following diagnostic steps will help prevent overlooking a simple problem. This is also where to begin diagnosis for a no-start condition. The first step in diagnosing any driveability problem is verifying the customer's complaint with a test drive under the conditions problem reportedly occurred.
Before entering self-diagnostics, perform a careful and complete visual inspection. Most engine control problems result from mechanical breakdowns, poor electrical connections or damaged/misrouted vacuum hoses. Before condemning the computerized system, perform each test listed in this article.
NOTE:
Perform all voltage tests with a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure.