Sub-Throttle Position Sensor
- Disconnect electrical connector from sub-throttle actuator and sub-throttle position sensor. See Figure.
- Remove screws and sub-throttle actuator. Ensure no clearance exists between throttle stop screw and throttle valve gear with sub-throttle valve fully closed. Perform STEP 1. See Fig 1.
- With sub-throttle valve fully closed, insert specified thickness feeler gauge between throttle stop screw and throttle valve gear. Check resistance between specified terminals. See SUB-THROTTLE POSITION SENSOR RESISTANCE SPECIFICATIONS table. Perform STEPS 2 and 3. See Fig 1.
- Replace or adjust sub-throttle position sensor if resistance is not within specification. Reinstall sub-throttle actuator and electrical connectors.
SUB-THROTTLE POSITION SENSOR RESISTANCE SPECIFICATIONS
| Application Type | Clearance In. (mm) | Terminals Tested | Ohmmeter Reading |
|---|---|---|---|
| Supra Turbo | 0 (0) | VTA & E2 | 300-6300 |
| " | .016 (.40) | IDL & E2 | 500 Or Less |
| " | .019 (.48) | IDL & E2 | No Continuity |
| " | Fully Open | VTA & E2 | 200-10,800 |
| " | " | VC & E2 | 3500-6500 |