A/T Models
- Disconnect electrical connector from park/neutral position switch, mounted on side of transmission or transaxle. Note terminal identification. See Fig 1.
- Using ohmmeter, check for continuity at specified terminals with gearshift in proper positions. See the PARK/NEUTRAL POSITION SWITCH SPECIFICATIONS table. If proper continuity cannot obtained, adjust switch. Replace switch if proper continuity cannot be obtained.
PARK/NEUTRAL POSITION SWITCH SPECIFICATIONS
| Application & Gearshift Position | Terminal Continuity |
|---|---|
| Park | 5 & 6, 4 & 7 |
| Reverse | 4 & 8 |
| Neutral | 5 & 6, 4 & 10 |
| Drive | 4 & 9 |
| 2 | 4 & 2 |
| Low | 4 & 3 |