Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 1995 >> Pickup Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - Remove/Install/Overhaul - 3.0L) >> Fuel System >> Cold Start Injector >> Removal

Cold Start Injector: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE  under FUEL SYSTEM. Disconnect electrical connector at cold start injector. Cold start injector is located on the inside of air intake chamber. See Figure.
  2. Remove union bolt, gaskets and disconnect fuel line from cold start injector. Remove retaining nuts, cold start injector and gasket from air intake chamber.
scientia non olet · About Mike's Workshop Manuals