Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 1994 >> Pickup Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - Basic Testing - V6) >> Ignition Checks >> Ignition Coil Resistance

Ignition Coil Resistance

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect wiring from ignition coil so ignition coil is isolated from system. Using ohmmeter, check primary resistance between ignition coil positive (+) and negative (-) terminals. See Fig 1.
  2. Check secondary resistance between ignition coil positive (+) terminal and high tension terminal (coil wire tower). See Fig 2. Replace ignition coil if resistance is not within specification. See appropriate IGNITION COIL RESISTANCE  table.
IGNITION COIL RESISTANCE - Ohms @ 68°F (20°C)

Application Primary Secondary
Pickup .36-.55 9000-15,400
Fig 1: Checking Ignition Coil Primary Resistance
G94E44580Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 2: Checking Ignition Coil Secondary Resistance
G94C44588Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals