Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Toyota >> 1992 >> 4Runner 2D Utility, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Distributor >> Removal (3.0L 3VZ-E)

Removal (3.0L 3VZ-E)

  1. Disconnect battery negative cable. Record spark plug wire locations in distributor cap and remove wires. Remove distributor cap and dust-proof packing seal ring. Disconnect distributor electrical connector.
  2. Set cylinder No. 1 to TDC of compression stroke. Ensure distributor rotor points in direction shown. See Fig 1. Remove distributor hold-down bolt. Remove distributor. Remove "O" ring from distributor housing and discard.
Fig 1: Aligning Rotor For Distributor Removal (3.0L 3VZ-E)
G92C25850Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals