TPMS Sensor - ID Learn Procedure - Continental: Setup
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Tesla Model S, 2019 Tesla Model S, 2018 Tesla Model S, 2017 Tesla Model S, and 2016 Tesla Model S. However, it is still accessible from the selected car via links, so may be relevant.
- Press the Power button and watch the display. When the display shows "ATEQ VT30", note the version number:
- If the version is EA1-07, refer to TN-14-92-005, "ATEQ TPMS Tool Firmware Update" to update the tool's firmware.
- If the version is higher than EA1-07, continue this procedure.
- In the Main Menu, use the up and down arrows to select Vehicle Selection , then press the Enter (DOWN LEFT ARROW) button.
- Use the up and down arrows to select Tesla , then press the Enter button.
- Use the up and down arrow to select Left Front .
- Hold the ATEQ tool near the valve stem on the left front tire, then press and hold the Read button until the sensor is read.
- Repeat steps 4 and 5 for the 3 remaining tires.
- Connect a laptop with Toolbox 3 to the vehicle.
- Unlock the vehicle gateway. See GATEWAY UNLOCK .
- In Toolbox 3, click the Actions tab, type "TPMS-LEARN" into the search field, click PROC_TPMS_X_TPMS-SENSOR-LEARN, click Run , and allow the routine to complete.
- Disconnect Toolbox and remove the laptop from the vehicle.