Center Console - Remove And Replace: Remove
NOTE:
The security controller currently on the vehicle will be transferred to the replacement center console. This will allow the vehicle/keys to function without the need for reconfiguration.
- Remove the center console assembly. See CENTER CONSOLE (REMOVE AND INSTALL) .
- Release the clips (x4) that attach the rear of the LH decor trim to the center console assembly
- Remove the screws (x4) that attach the rear of LH center console bright strip to the center console assembly.
Tip: Use of the following tool(s) is recommended:
- Torx T20 socket
- Release the tabs (x3) that attach the rear of the LH center console bright strip to the center console assembly, and then partially release the bright strip from the assembly.
- Repeat the step 2 through step 4 for the RH side of the center console.
- Release the clips (x6) that attach the cup holder decor panel to the cup holder assembly, and then separate the cup holder decor panel from the center console assembly.
- Disconnect the electrical connector from the security body controller module, and then remove the cup holder decor panel from the vehicle.
- Remove the screws (x2) that attach the security body controller module to the cup holder decor panel, and then remove the security body controller module from the panel.
Tip: Use of the following tool(s) is recommended:
- Torx T20 socket
- Repeat step 2 through step 7 for the new center console assembly.