Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Tesla >> 2021 >> Model S Performance >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Electrical System -- Model Y (2 Of 2)) >> Wipers And Washers >> Wiper Module - Remove And Replace >> Install

Wiper Module - Remove And Replace: Install

WARNING: This page is about a different car, the 2024 Tesla Model Y, 2023 Tesla Model Y, 2022 Tesla Model Y, 2021 Tesla Model Y, and 2020 Tesla Model Y. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the wiper module facing upside down, connect the electrical connector. Afterwards, rotate the wiper module towards the rear of the vehicle to ensure proper harness clearance.
    CAUTION: Check the harness to make sure it is not routed incorrectly.
    G14834053Courtesy of TESLA, INC.
  2. Carefully push the wiper module towards the rear of the vehicle so that the rubber anchor inserts into the bracket on the bulkhead.
    G14834054Courtesy of TESLA, INC.
  3. Install the bolts that attach the wiper module to the vehicle.

    7 N.m (5.2 ft-lbs) 

    NOTE: Use of the following tool(s) is recommended:
    • 10 mm socket
    • 2 in extension
    G14834055Courtesy of TESLA, INC.
  4. Install the cowl screen panel. See PANEL - COWL SCREEN (REMOVE AND REPLACE) .
  5. Enable Service Mode through the touchscreen. See SERVICE MODE
  6. Perform a software reinstall. See SOFTWARE REINSTALL - TOUCHSCREEN .
  7. Run the Wiper Replacement procedure: on the touch screen, touch Service > Closures > Windows > Wiper replacement  , touch Run  , and allow the routine to complete.
    G00624423Courtesy of TESLA, INC.
  8. Verify the operation of the windshield washers and wipers.
scientia non olet · About Mike's Workshop Manuals