Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Tesla >> 2017 >> Model 3 Base >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Wheel And Tires -- Model 3 >> Tire Pressure Monitoring System (TPMS) >> TPMS (BLE) - Sensor ID Drive Learn >> Procedure

TPMS (BLE) - Sensor ID Drive Learn: Procedure

  1. Open LH front door.
  2. Connect to the vehicle with Toolbox 3.0.
  3. In Toolbox, select the Actions/Autodiag  tab, and then enter "TPMS vsec".
  4. Select PROC_VCSEC_X_TPMS-ERASE-SENSOR-ID  , and then click Run  .
    NOTE: Click the "X" at the top of the window after the routine is complete.
  5. On the touchscreen, confirm that all TPMS values have been erased.
    NOTE: TPMS values will display a dash if erased.
  6. Disconnect the laptop from the vehicle.
  7. Test drive the vehicle to at least 15 mph (24 kph) for 1-3 minutes to reconnect the TPMS sensors.
  8. Confirm on the vehicle touchscreen that all 4 TPMS sensors are providing tire pressure readings.
scientia non olet · About Mike's Workshop Manuals