Sensor - HVAC - Light/Temperature/Humidity - Remove And Replace: Installation

Installation procedure is the reverse of removal, except for the following:

CAUTION: Do not touch the camera lens at any point during this procedure.

NOTE: Be careful not to block the front of the camera with the HVAC light/temperature/humidity electrical harness. Route the harness around the camera lens, not in front of it.

Courtesy of TESLA, INC.

Clean the inside surface of the windshield with glass cleaner and make sure it is fully dry before installing the forward facing camera.
Perform a camera pre-calibration Camera - Forward Facing (Pitch Verification) .