Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Tesla >> 2014 >> Model S Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Electrical System (3 Of 3) -- Model X) >> Wipers And Washers >> Wiper Module - Remove And Replace >> Install

Wiper Module - Remove And Replace: Install

WARNING: This page is about a different car, the 2024 Tesla Model X, 2023 Tesla Model X, 2022 Tesla Model X, and 2021 Tesla Model X. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connector to the wiper module.
    G15438430Courtesy of TESLA, INC.
  2. Position the wiper module to the vehicle, and then install the bolts that attach the wiper module to the vehicle.

    9 N.m (6.6 ft-lbs) 

    Tip: Use of the following tool(s) is recommended:

    • 10 mm socket
    • Ratchet/torque wrench
    G15438431Courtesy of TESLA, INC.
  3. Install the cowl screen. See Panel - Cowl Screen (Remove and Replace) .
  4. Connect LV power. See LV POWER (DISCONNECT AND CONNECT) .
  5. Calibrate the rear doors.
    NOTE: If the "Calibration Needed" message appears on the vehicle touchscreen, touch and hold Calibrate  to calibrate the rear doors.
scientia non olet · About Mike's Workshop Manuals