Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Tesla >> 2012 >> Model S >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Electrical System (3 Of 3) -- Model S) >> Keyless Entry And Security >> Module - Bluetooth Low Energy (BLE) - Front - Remove And Replace >> Remove

Module - Bluetooth Low Energy (BLE) - Front - Remove And Replace: Remove

WARNING: This page is about a different car, the 2024 Tesla Model S, 2023 Tesla Model S, 2022 Tesla Model S, and 2021 Tesla Model S. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front fascia assembly. See Fascia Assembly - Front (Remove and Install) .
  2. Disconnect the electrical harness from the BLE module.
    CAUTION: DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.
    G15092826Courtesy of TESLA, INC.
  3. Remove the screw that attaches the T badge support to the front fascia.

    Tip: Use of the following tool(s) is recommended:

    • Torx T25 socket
    • 4 in extension
    • Flex head ratchet/flex head torque wrench
    G15092827Courtesy of TESLA, INC.
  4. Release the T badge support tabs from the front fascia, and then remove the T badge support from the front fascia.
    G15092828Courtesy of TESLA, INC.
    G15092829Courtesy of TESLA, INC.
  5. Remove the screws that attach the T badge to the T badge support.

    Tip: Use of the following tool(s) is recommended:

    • Torx T25 socket
    • 4 in extension
    • Flex head ratchet/flex head torque wrench
    G15092830Courtesy of TESLA, INC.
scientia non olet · About Mike's Workshop Manuals