Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Suzuki >> 2013 >> Kizashi Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Communication System) >> Diagnostic Information and Procedures >> Troubleshooting for Communication Bus Off >> Communication Check >> P/S control module

P/S control module

WARNING: This page is about a different car, the 2010 Suzuki Kizashi. However, it is still accessible from the selected car via links, so may be relevant.
  1. Push engine switch to change ignition mode to "OFF".
  2. Connect "E10" connector to P/S control module.
  3. Push engine switch to change ignition mode to "ON".
  4. Select "Communication Bus Check" under "Bus Check" menu of SUZUKI scan tool.
  5. Confirm the CAN communication that control modules, sensors and P/S control module have been already connected on is in normal condition.
  6. If any malfunction is found, substitute a known-good P/S control module and recheck DTC, see P/S CONTROL MODULE REMOVAL AND INSTALLATION .
scientia non olet · About Mike's Workshop Manuals