Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Suzuki >> 2013 >> Kizashi Base, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Aux. Emission Control Devices >> Repair Instructions >> Vacuum Passage Inspection

Vacuum Passage Inspection

  1. Start engine and run it at idle speed.
  2. Disconnect vacuum hose from EVAP canister purge valve.
  3. With finger placed over disconnected end of hose, check if vacuum is applied.

    If vacuum is not applied, clean vacuum passage by blowing compressed air.

scientia non olet · About Mike's Workshop Manuals