Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Suzuki >> 2012 >> SX4 Base >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Diagnostic Information and Procedures >> DTC P0575: Cruise Control Input Circuit >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: If you do not select a suitable route and take proper precautions when performing a road test, an accident can occur.
  • Select a level road with no traffic to minimize the risk of accident.
  • Perform the test extremely carefully.
  • Perform the road test using 2 persons, a driver and an assistant.
NOTE: If DTC other than aimed DTC are previously detected in DTC confirmation procedure, be sure to troubleshoot DTC previously detected.
  1. With ignition switch turned OFF, connect scan tool to DLC.
  2. Turn ON ignition switch and clear DTC.
  3. Start engine and warm up to normal operating temperature.
  4. Press cruise MAIN (ON/OFF) switch once.
  5. Drive vehicle at 40 km/h (25 mph) or higher for 3 min. or more.
  6. Stop vehicle.
  7. Check DTC.
scientia non olet · About Mike's Workshop Manuals