BCM (Body Control Module): Removal and Installation: Installation

WARNING: This page is about a different car, the 2011 Suzuki Equator. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

NOTE:

When replacing the BCM, it must be configured. Refer to [BODY CONTROL SYSTEM: CONFIGURATION ].
When replacing the BCM, perform initialization of immobilizer system and registration of all immobilizer system ignition key IDs. Refer to [BODY CONTROL SYSTEM: CONFIGURATION ].
When replacing the BCM, perform ID registration procedure of low tire pressure warning system. Refer to [ID REGISTRATION PROCEDURE ].
When replacing the BCM, if equipped with remote keyless entry, register the remote keyless entry system keyfob ID codes. Refer to [ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT ].
When replacing the BCM, if equipped with VOC, perform adjustment procedure for the steering angle sensor. Refer to [ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION ] (type 2) or [ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION ] (type 3).