Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2024 >> Ascent Base >> Repair and Diagnosis (Single Page) >> Body & Frame >> Seats >> Seat System - Seats >> Power Seat System >> Removal >> Power Seat Control Module

Power Seat Control Module

  1. Prior to starting work, check the following precautions. Ref. to SEATS>GENERAL DESCRIPTION>CAUTION .
  2. When the seat position memory Control Module or the front seat equipped with the seat position memory Control Module with registered memory was replaced with a new part, perform the variant work. (Model with seat position memory) Ref. to POWER SEAT MEMORY(DIAGNOSTICS)>WORK SUPPORT>OPERATION
  3. Raise the seat cushion by operating the switch.
  4. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  5. Remove the driver's seat from the vehicle.
  6. Remove the ECM seat memory.
    1. Disconnect the connector.
    2. Remove the nuts and remove the ECM seat memory.
G13201133Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals