Vehicle Information Registration: Notes

Perform when replacing stereo camera. (Do not perform when performing stereo camera re-adjustment and inspection)

1. Register the vehicle information according to the procedure of "Parameter selection", and confirm the vehicle information content in "Parameter check".
   • Parameter selection
   NOTE:

   • To check the applied model, refer to the "Model number plate" attached to the vehicle. Ref. to IDENTIFICATION .
   • If you entered a wrong applied model, re-enter.
   1. Using the Subaru Select Monitor, select [Selection of Parameter] in [Work Support] of [EyeSight]. Ref. to COMMON (DIAGNOSTICS)>WORK SUPPORT .
   2. Check the applied model and option code indicated on the "Model number plate". Ref. to IDENTIFICATION .
   3. Enter the applied model (alphanumeric characters) and press the Enter key.
   4. When the option code input screen appears after entering the applied model, enter the option code (alphanumeric characters), and press the Enter key.
   5. When the confirmation screen indicating the vehicle information appears, check that the correct applied model and option code are displayed and click [OK].
   NOTE: When the displayed applied model and option code are different from those of the vehicle, click [OK] and then perform the registration operation again.
   NOTE: Note that checking the digit corresponding to option code is not required if "*" or "_" is displayed for option code.