Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2023 >> Crosstrek Base, Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel Injection System (Except For HEV) >> Fuel Insulator >> Installation >> 2.5 L Model

2.5 L Model

  1. Install the fuel pipe insulator.
    CAUTION:
    • If substantial amount of fuel or parts cleaner come into contact with the fuel pipe insulator, replace it with a new fuel pipe insulator  .
    • If only small amount of fuel comes into contact with the fuel pipe insulator, wait for the fuel to evaporate before installing it  .
  2. Install the bolt securing the engine wiring harness.

    Tightening torque: 

    T1: 6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

    T2: 19 N.m (1.9 kgf-m, 14.0 ft-lb)

  3. Install the clip (A) and clip (B) securing the engine wiring harness.
  4. Connect the connector (C) to the outlet engine coolant temperature sensor.
    Fig 1: Engine Wiring Harness Bolts With Torque Specification
    G13875392Courtesy of SUBARU OF AMERICA, INC.
  5. Install the intake manifold assembly. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>INTAKE MANIFOLD ASSEMBLY>INSTALLATION>2.5 L MODEL .
  6. Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO (EXCEPT FOR HEV))>AIR INTAKE BOOT>INSTALLATION .
  7. Connect the ground terminal to battery sensor, Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About Mike's Workshop Manuals