Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2022 >> WRX Base, Automatic CVT Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Reverse Automatic Braking System >> Reverse Automatic Braking Control Module >> Installation

Reverse Automatic Braking Control Module: Installation

  1. Install the sonar control module assembly, and then connect the connector.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

  2. Install the trunk trim panel side. Ref. to EXTERIOR/INTERIOR TRIM>TRUNK ROOM TRIM>INSTALLATION
  3. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
scientia non olet · About Mike's Workshop Manuals