Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2022 >> Ascent Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Anti-Theft System - Security And Locks) >> Body Integrated Unit >> Installation

Body Integrated Unit: Installation

WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • When the control module related to immobilizer has been replaced, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to "Type B" described in "REGISTRATION MANUAL FOR IMMOBILIZER". (Models without keyless access with push button start system except for CO model) 
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM"  . Ref. to AIRBAG SYSTEM>General Description>CAUTION .
  1. When replacing the body integrated unit with a new part, install the relay (a) and the fuse (b) to the relay holder.
    G13606806Courtesy of SUBARU OF AMERICA, INC.
  2. Install the body integrated unit (fuse & relay box).

    Tightening torque: 

    7.5 N.m (0.8 kgf.m, 5.5 ft.lb)

  3. Install the knee airbag module. Ref. to AIRBAG SYSTEM>Knee Airbag Module>INSTALLATION .
  4. Install the cover LWR driver.
  5. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About Mike's Workshop Manuals