Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2021 >> Outback Limited XT >> Repair and Diagnosis >> Engine Mechanical >> Engine Lubrication System (2.4L) >> Oil Level Switch >> Installation >> When The CROSSMEMBER COMPL Front Was Removed

When The CROSSMEMBER COMPL Front Was Removed

  1. Use a new O-ring to install the oil level switch, and secure the harness with the clip.
    NOTE: Apply engine oil to O-ring.

    Tightening torque: 

    6.4 N.m (0.7 kgf.m, 4.7 ft.lb)

    G13949407Courtesy of SUBARU OF AMERICA, INC.
  2. Secure the harness with clip, and connect the connector.
    G13949408Courtesy of SUBARU OF AMERICA, INC.
  3. Install the crossmember COMPL front. Ref. to FRONT SUSPENSION>CROSSMEMBER>INSTALLATION .
  4. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About Mike's Workshop Manuals