Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2021 >> Outback Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Emission Control Systems (Aux. Emission Control Devices) (2.4L)) >> Leak Check Valve Assembly >> Inspection >> Check Pressure Sensor

Check Pressure Sensor

WARNING: This page is about a different variant/trim than selected.
  1. Using new dry cell batteries, connect the battery positive terminal to terminal No. 6 and the battery ground terminal to terminal No. 8, and connect the circuit tester positive terminal to terminal No. 7 and the circuit tester ground terminal to terminal No. 8.
    NOTE:
    • Using a circuit tester, check that the initial voltage of each dry-cell battery is 1.6 V or more. And also check that the voltage of three batteries in series is between 4.8 - 5.2 V.
    • For power supply, 5 V DC constant voltage power source can also be used.
    G13948659Courtesy of SUBARU OF AMERICA, INC.
  2. Check the voltage at a normal atmospheric pressure.
    NOTE: The atmospheric pressure at higher altitude is lower than normal. Therefore, the voltage is lower than the standard value.
    Terminal No. Standard
    7 (+) and 8 (-) Approx. 3.5 V (when 25°C (77°F))
  3. Connect the battery positive terminal to terminal No. 3 and the battery ground terminal to terminal No. 4, and check that there is a voltage drop from the voltage measured in step 2 when the vacuum pump is operated.
G13948660Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals