DTC B2257: Meter Communication Open

DTC detecting condition: 

Detected when LVDS communication with combination meter is not possible.

Trouble symptom: 

• Meter LCD cannot be displayed.
• Vehicle setting cannot be customized partially (EyeSight, Reverse Automatic Braking, Auto Start Stop system, etc.).

1. CHECK DTC  .
   1. Using the Subaru Select Monitor, perform the clear memory of [Cockpit Control]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
   2. Turn the ignition switch OFF → ON.
   3. Read the DTC of [Cockpit Control] using the Subaru Select Monitor. Ref. to Cockpit Control (Diagnostics)>Diagnostic Trouble Code (DTC) .

   Is DTC B2257 or B2258 displayed? (Current malfunction)

   Yes:  Go to  2 .

   No:  Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

   NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
2. CHECK CONNECTOR  .

   Check the harness between the cockpit control module connector and the combination meter.

   Is the check result OK?

   Yes:  Go to  3 .

   No:  Repair the harness or replace the components.

3. CHECK COMBINATION METER  .

   Perform the inspection according to the diagnosis for combination meter. Ref. to COMBINATION METER (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .

   Is the check result OK?

   Yes:  Replace the cockpit control module. Ref. to ENTERTAINMENT & MONITORING>COCKPIT DISPLAY .

   No:  Replace the combination meter. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER .