Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2021 >> Outback Base >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Eyesight System >> Camera Adjustment, Inspection >> Procedure >> Vehicle Information Registration >> Parameter Selection

Parameter Selection

NOTE:
  • To check the applied model, refer to the "Model number plate" attached to the vehicle  . Ref. to IDENTIFICATION .
  • If you entered a wrong applied model, you can re-write it  .
  1. Using the Subaru Select Monitor, select [Selection of Parameter] from the work support item list of [EyeSight]. Ref. to COMMON (DIAG)>WORK SUPPORT .
  2. Check the applied model and option code indicated on the "Model number plate". Ref. to IDENTIFICATION .
  3. Enter the applied model (alphanumeric characters) and press the Enter key.
  4. When the option code input screen appears after entering the applied model, enter the option code (alphanumeric characters), and press the Enter key.
  5. When the confirmation screen indicating the vehicle information appears, check that the correct applied model and option code are displayed and click the [OK] button.
NOTE: When the displayed applied model and option code are different from those of the vehicle, click the [OK] button and then perform the registration operation again  .

Note that checking the digit corresponding to option code is not required if "*" or "_" is displayed for option code  .

scientia non olet · About Mike's Workshop Manuals