Power Seat Memory System (Diagnostics)

• Basic Diagnostic Procedure
  • Procedure
• Check List For Interview
  • Check
    • Notes
    • Power Seat Memory System
    • Door Mirror System
• General Description
  • Caution
    • Airbag System
    • Power Seat Memory/Door Mirror System
  • Inspection
    • Basic Inspection
  • Preparation Tool
    • Special Tool
    • General Tool
  • System Block Diagram
• Electrical Component Location
  • Location
• Control Module I/O Signal
  • Electrical Specification
    • Power Seat And Remote Control Mirror Control Module
• Inspection Mode
  • Procedure
    • Notes
    • Inspection Mode 1
    • Inspection Mode 2
    • Inspection Mode 3
    • Inspection Mode 4
    • Inspection Mode 5
• Diagnostic Procedure For Subaru Select Monitor Communication
  • Inspection
• Data Monitor
  • Operation
  • List
• Freeze Frame Data
  • Operation
  • List
• Active Test
  • Operation
  • List
• Customize
  • Operation
  • List
• Work Support
  • Operation
• Diagnostic Trouble Code (DTC)
  • Operation
  • List
• Diagnostic Procedure With Diagnostic Trouble Code (DTC)
  • DTC B2600: Lin Communication
  • DTC B2601: Lin Circuit Low
  • DTC B2602: Vehicle Speed Control
  • DTC B2603: EPB Control
  • DTC B2604: Power Seat Memory EEPROM
  • DTC B2605: Battery Control Low
  • DTC B2606: Power Seat Position Sensor Circuit Low
  • DTC B2607: Seat Motor Relay Failure
  • DTC B2608: Seat SW Failure
  • DTC B2609: IG
  • DTC B260A: Acc
  • DTC B2621: Mirror SW Anomalous State
  • DTC B2631: Mirror D Motor Circuit Anomalous State
  • DTC B2632: Mirror D Sensor Circuit Anomalous State
  • DTC B2641: Mirror P Motor Circuit Anomalous State
  • DTC B2642: Mirror P Sensor Circuit Anomalous State
• Diagnostics With Phenomenon
  • List
    • Power Seat System
    • Mirror Control System
  • Inspection
    • Mirror Surface Does Not Move When Operated Manually (Both Sides/One Side)
    • Mirror Surfaces Position Is Not Restored Or Recovered While Being Linked With Reverse Operation (Manual Operation Is Possible)
    • Mirror Surface Moves Automatically
    • Memory Is Not Reloaded For The Mirror Surface Only (Manual Operation Is Possible)
    • Cannot Be Customized (Manual Operation Is Possible)
    • The Mirror Position Cannot Be Restored/Registered With The Memory Switch
    • The Mirror Position Cannot Be Restored/Registered With The Smart Key
    • The Mirror Position Cannot Be Restored/Registered With The Driver Monitoring System