Adjustment Value Clear

Perform when replacing stereo camera. (Do not perform when performing stereo camera re-adjustment and inspection)

1. Using the Subaru Select Monitor, select [Clear adjustment value] from the work support item list of [EyeSight]. Ref. to COMMON (DIAG)>WORK SUPPORT .
2. When [Clear the adjustment value. Caution! Do not perform the procedure with any conditions other than specified in the service manual.] is displayed, select [OK].
3. When [Clearing adjustment value...] is displayed, wait until it finishes.
4. When the adjustment value clear operation is finished correctly, [Adjustment value clear OK! The adjustment value clear was finished correctly. Turn the IGN SW to OFF for five seconds or more. (CODE 1F00)] is displayed. Select [OK] to finish.
5. Turn the ignition switch to OFF and wait for approx. 5 seconds or more.
   CAUTION: If the ignition switch OFF period is short, the adjustment value clear operation cannot be performed correctly.
6. Next, perform the camera all adjustment mode (replacement/removal). Ref. to EYESIGHT>Camera Adjustment, Inspection>PROCEDURE>CAMERA ALL ADJUSTMENT MODE (REPLACEMENT/REMOVAL) .