VDCCM Parameter Selection

NOTE:

When the VDCCM & H/U is replaced with a replacement part, be sure to perform the parameter selection/registration to the VDCCM & H/U using this function.
To check the applied model, refer to the "Model number plate" attached to the vehicle. Ref. to IDENTIFICATION .
If you entered a wrong applied model, you can re-write it.
When the registration has not been performed, the DTC code [Selected Parameter] is detected together with the ABS/EBD/VDC warning light illumination.
This function can be used for the replacement part of VDCCM & H/U.

Using the Subaru Select Monitor, select [Selected Parameter] on the [Work Support] display.
- Except for hybrid model: Ref. to BRAKE CONTROL (DIAGNOSTICS)>WORK SUPPORT .
- Hybrid model: Ref. to BRAKE CONTROL (DIAGNOSTICS) (HEV)>WORK SUPPORT .
Check the applied model and option code indicated on the "Model number plate". Ref. to IDENTIFICATION .
Enter the applied model (alphanumeric characters) and click the [OK] button.
When the option code input screen appears after entering the applied model, enter the option code (alphanumeric characters), and click the [OK] button.
When the confirmation screen indicating the vehicle information appears, check that the correct applied model and grade are displayed and click the [OK] button.
NOTE: When the displayed applied model and grade are different from those of the vehicle, click the [OK] button and then perform the registration operation again.
Execute the Clear Memory Mode after parameter selection and registration operations because the DTC for [Selected Parameter] is memorized. Ref. to COMMON (DIAG)>CLEAR MEMORY .