Power Steering Assist Enabled

Detecting condition:

Defective combination meter
Defective harness

Trouble symptom:

When the ignition switch is turned to ON (engine OFF), the STEERING warning light does not illuminate.

NOTE: It is operating normally if the warning light illuminates when the ignition switch is turned to ON (engine OFF), and turns off approximately two seconds after engine start.

CHECK ILLUMINATION OF OTHER LIGHTS .
Turn the ignition switch to ON. (Engine OFF)

Do other warning lights illuminate?

Yes : Go to 2.

No : Check the combination meter. Refer to ACTIVE TEST .
CHECK LAN SYSTEM .
Check the LAN system. Refer to LAN SYSTEM (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE .

Is the check result OK?

Yes : Go to 3.

No : Perform the diagnosis for LAN system.
CHECK COMBINATION METER .
Check the combination meter. Refer to COMBINATION METER (DIAGNOSTICS)>Basic Diagnostic Procedure .

Is the check result OK?

Yes : Current condition is normal.

No : Replace the combination meter. Refer to INSTRUMENTATION/DRIVER INFO>COMBINATION METER .