Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (CVT Transaxle (Tr690) (Service Information)) >> Primary Speed Sensor >> Installation

Primary Speed Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION: If water or oil contacts the connector terminal of primary speed sensor, replace it with a new part.
  1. Install the primary speed sensor using a new O-ring, and connect the connector.
    NOTE: Apply CVTF to the O-rings.

    Tightening torque: 

    5 N.m (0.5 kgf-m, 3.7 ft-lb)

  2. Install the intercooler. Refer to INTAKE (INDUCTION) (H4DOTC)>Intercooler>INSTALLATION .
  3. Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About Mike's Workshop Manuals