Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Starting System & Charging System (2.4L)) >> Battery >> Removal

Section 4 (Engine Starting System & Charging System (2.4L)): Battery: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
  2. Disconnect the connector from battery sensor. (When the battery is not replaced)
  3. Remove the battery sensor. (When replacing the battery) Refer to STARTING/CHARGING SYSTEMS (H4DOTC)>Battery Sensor>REMOVAL .
  4. Disconnect the battery positive terminal, and remove the battery terminal holder.
  5. Remove the battery cable holder.
  6. Remove the battery holder.
    G13619460Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the battery.
scientia non olet · About Mike's Workshop Manuals