Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Starting System & Charging System (2.4L)) >> Auto Start Stop DC/DC Converter >> Removal >> Auto Start Stop DC/DC CONVERTER 1

Auto Start Stop DC/DC CONVERTER 1

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the camera control assembly. (Model with front camera) Refer to ENTERTAINMENT & MONITORING>Control Unit>REMOVAL>CAMERA CONTROL MODULE .
  3. Disconnect the connector from the Auto Start Stop DC/DC converter 1.
    G13619496Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the Auto Start Stop DC/DC converter 1 from the vehicle.
    G13619497Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the Auto Start Stop DC/DC converter 1 from the bracket.
G13619498Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals