Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Emission Control Systems (Aux. Emission Control Devices) (2.4L)) >> PCV Pipe >> Installation

PCV Pipe: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Connect the quick connector of the PCV pipe assembly to the cylinder block pipe section.
    CAUTION:
    • Check that there is no damage or dust on the quick connector. If necessary, clean the seal surface of the pipe.
    • Make sure that the quick connector is securely connected.
    G13198548Courtesy of SUBARU OF AMERICA, INC.
  2. Connect the connector (A) and terminal (B).

    Tightening torque: 

    15.5 N.m (1.6 kgf-m, 11.4 ft-lb)

    G13619945Courtesy of SUBARU OF AMERICA, INC.
  3. Install the PCV pipe assembly to the intake manifold assembly.
    G13198545Courtesy of SUBARU OF AMERICA, INC.
  4. Connect the PCV pipe assembly to the intake duct No. 1 with a new O-ring.
    CAUTION:
    • Make sure there are no damage or dust on connections. If necessary, clean the seal surface of the pipe.
    • Confirm that the connections are secure.
    NOTE: It is possible to install with the spring locked.
    G13619535Courtesy of SUBARU OF AMERICA, INC.
  5. Install the intake duct No. 2. Refer to INTAKE (INDUCTION) (H4DOTC)>Intake Duct>INSTALLATION>INTAKE DUCT NO. 2 .
  6. Install the V-belt tensioner assembly. Refer to MECHANICAL (H4DOTC)>V-belt>INSTALLATION>V-BELT TENSIONER ASSEMBLY .
  7. Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About Mike's Workshop Manuals