Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2020 >> Impreza Base, 4D Wagon, Automatic CVT Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel Injection System (Except For HEV) >> Crankshaft Position Sensor >> Inspection >> Crankshaft Position Sensor

Crankshaft Position Sensor

  1. Disconnect the ground terminal from 12V engine restart battery sensor. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  2. Prepare an oscilloscope.
  3. Disconnect the connector from ECM. Refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>ENGINE CONTROL MODULE (ECM)>REMOVAL .
  4. Attach the ST between the ECM, engine wiring harness and the bulkhead wiring harness. Refer to ENGINE (DIAGNOSTICS) (H4DO (EXCEPT FOR HEV))>GENERAL DESCRIPTION>PREPARATION TOOL>HOW TO USE CHECK BOARD .

    Special tool: 

    CHECK BOARD (18460AA180)

  5. Connect the probe to ST.
    G13223954Courtesy of SUBARU OF AMERICA, INC.
    Terminal No. Probe
    (E158) No. 66 +
    (B134) No. 69 -
  6. Connect the ground terminal to 12V engine restart battery sensor. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  7. Start the engine and let it idle.
  8. Check the waveforms and voltage.
    NOTE: For waveform and voltage, refer to ENGINE (DIAGNOSTICS) (H4DO (EXCEPT FOR HEV))>CONTROL MODULE I/O SIGNAL>ELECTRICAL SPECIFICATION .
  9. After inspection, install the related parts in the reverse order of removal.
    NOTE: For installation procedures of ECM connectors, refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>ENGINE CONTROL MODULE (ECM)>INSTALLATION .
scientia non olet · About Mike's Workshop Manuals