Active Test: Operation

WARNING: This page is about a different variant/trim than selected.

On [Start] screen, select [Diagnosis].
On [Vehicle selection] screen, enter vehicle information and select [OK].
On [Main Menu] screen, select [Each System].
On [Select System] screen, select [Plug-in Battery Charger].
On [Select Function] screen, select [Active Test].
On [Active Test] screen, select an item to be checked.
NOTE:
- For detailed operation procedures, refer to "Help" of application.
- If the connector with the Subaru Select Monitor becomes disconnected or a communication error occurs during the active test, use sufficient caution because driving may not be possible (READY OFF).
- After the active test is finished, turn IG OFF and then resume work.