Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2019 >> Crosstrek Base, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (Diagnostics) (Except For HEV) (3 Of 4) >> Diagnostic Procedure With Diagnostic Trouble Code (DTC) >> DTC P1C00: Battery Monitor Module "A" Performance >> Notes

DTC P1C00: Battery Monitor Module "A" Performance: Notes

  1. - 

    DTC detecting condition: 

    Immediately at fault recognition

    NOTE: After the faulty parts are repaired or replaced, perform the final check in Basic Diagnostic Procedure. Refer to ENGINE (DIAGNOSTICS) (H4DO (EXCEPT FOR HEV))>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .
  1. CHECK DTC.

    Using the Subaru Select Monitor or a general scan tool, read the DTC of [Engine]. Refer to ENGINE (DIAGNOSTICS) (H4DO (EXCEPT FOR HEV))>DIAGNOSTIC TROUBLE CODE (DTC) .

    Is DTC P1C00 displayed? (Current malfunction)

    Yes: 

    Replace the battery sensor. Refer to STARTING/CHARGING SYSTEMS (H4DO (EXCEPT FOR HEV))>BATTERY SENSOR .

    No: 

    Even if DTC is detected, it has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

scientia non olet · About Mike's Workshop Manuals