Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2019 >> Crosstrek Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Power Rear Gate System) >> Power Rear Gate Touch Sensor >> Removal

Power Rear Gate Touch Sensor: Removal

WARNING: This page is about a different car, the 2019 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the trim panel assembly rear gate. Ref. to EXTERIOR/INTERIOR TRIM>REAR GATE TRIM>REMOVAL .
  3. Remove the stopper rubber rear gate.
    G13201770Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the power rear gate touch sensor.
    1. Disconnect the connector.
    2. Release the clips, and then remove the power rear gate touch sensor.
    G13201771Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals