PRG Opener Button Does Not Function
NOTE:
Before performing diagnosis, initialize PRG SYS by opening PRG in manual operation, and then operating the power rear gate auto closer from the partially latched state.
- CHECK DTC.
Read the DTC of [Power Rear Gate] using the Subaru Select Monitor. Ref. to POWER REAR GATE (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
Are any DTCs displayed?
Yes: Perform the diagnosis for the displayed DTCs.
No : Go to 2.
- CHECK DATA MONITOR.
Using Subaru Select Monitor, check [R/G Open SW]. Ref. to POWER REAR GATE (DIAGNOSTICS)>DATA MONITOR .
Does the display switch between "OFF", "tap" and "press and hold" according to PRG opener button operation?
Yes: Switch input signal is normal.
No : Go to 3.
- CHECK BODY INTEGRATED UNIT.
- For models with keyless access Perform STEP 6 and subsequent procedures in "REAR GATE CANNOT BE UNLOCKED WITH THE REAR GATE OPENER BUTTON" in KPS (DIAGNOSTICS). Ref. to KEYLESS ACCESS WITH PUSH BUTTON START (DIAGNOSTICS)>DIAGNOSTICS WITH PHENOMENON>INSPECTION>REAR GATE CANNOT BE UNLOCKED WITH THE REAR GATE OPENER BUTTON .
- For models without keyless access Perform "CHECK REAR GATE OPENER BUTTON CIRCUIT" in Door Lock Control System. Ref. to SECURITY AND LOCKS>DOOR LOCK CONTROL SYSTEM>INSPECTION>CHECK REAR GATE OPENER BUTTON CIRCUIT .
Is the check result OK?
Yes: Replace Power rear gate Control Module. Ref. to POWER REAR GATE SYSTEM>POWER REAR GATE CONTROL MODULE .
No : Repair it according to each inspection.