Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2018 >> WRX STI >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Lubrication System (Except For STI)) >> Oil Level Switch >> Installation >> When Front CROSSMEMBER Has Been Removed

When Front CROSSMEMBER Has Been Removed

WARNING: This page is about a different variant/trim than selected.
  1. Install the oil level switch and the clip (A) to the oil pan upper.
    NOTE:
    • Use new O-rings.
    • Apply a coat of engine oil to the O-rings.

    Tightening Torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

    G09476529
  2. Connect the connector of oil level switch to the engine wiring harness, and install the clip (A) securing the harness.
    G09476614
  3. Install the front crossmember. Ref. to FRONT SUSPENSION>Front Crossmember>INSTALLATION .
scientia non olet · About Mike's Workshop Manuals