Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2018 >> Outback 3.6R Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Lubrication System (H4DO)) >> Oil Level Switch >> Removal

Oil Level Switch: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the under cover. Ref. to EXTERIOR/INTERIOR TRIM>Front Under Cover>REMOVAL .
  3. Drain the engine oil. Ref. to LUBRICATION(H4DO)>Engine Oil>REPLACEMENT .
  4. Disconnect the oil level switch connector from the engine wiring harness, and remove the clip (A) securing the harness.
    G10263077Courtesy of SUBARU OF AMERICA, INC.
  5. Remove clip (A) from the oil pan upper, and remove the oil level switch.
    G08580513Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals