Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2018 >> Impreza Base, 4D Sedan, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Transmission Control Systems) >> Select Cable >> Removal

Select Cable: Removal

WARNING: This page is about a different car, the 2018 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
  1. Shift the select lever to "N" range.
  2. Disconnect the ground cable from battery. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  3. Lift up the vehicle.
  4. Remove the center exhaust cover.
    G12392837Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the snap pin and washer from the shifter arm.
    CAUTION: Do not apply excessive load while holding the part (a).
    G12392838Courtesy of SUBARU OF AMERICA, INC.
    G12392839Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the plate assembly from the transmission case.
    G12392840Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect the cable from arm COMPL.
    CAUTION: Do not apply excessive load while holding the part (a).
    G12392841Courtesy of SUBARU OF AMERICA, INC.
    G12392842Courtesy of SUBARU OF AMERICA, INC.
  8. Raise the claw of clamp to remove the cable from bracket.
    G12392843Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the select cable from plate assembly.
scientia non olet · About Mike's Workshop Manuals