Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2018 >> Impreza Base, 4D Sedan, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Control/Fuel System) >> Crankshaft Position Sensor >> Installation

Crankshaft Position Sensor: Installation

WARNING: This page is about a different car, the 2018 Subaru Crosstrek. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the crankshaft position sensor to the cylinder block, and connect the connector to the crankshaft position sensor.

    Tightening torque: 

    6.4N.m (0.7kgf-m, 4.7ft-lb) 

  2. Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO)>Air Intake Boot>INSTALLATION .
  3. Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About Mike's Workshop Manuals