VDCCM Parameter Selection

NOTE:

When the VDCCM & H/U is replaced with a replacement part, be sure to perform the parameter selection/registration to the VDCCM & H/U using this function.
To check the applied model, refer to the "Model number plate" attached to the vehicle. Ref. to IDENTIFICATION .
If you entered a wrong applied model, you can re-write it.
When the registration has not been performed, the DTC code "Parameter" is detected together with the ABS/EBD/VDC warning light illumination.
This function can be used for the replacement part of VDCCM & H/U.

Perform selection of parameter.
1. Connect the Subaru Select Monitor.
  NOTE: For detailed operation procedures, refer to "Application help".
2. Turn the ignition switch to ON.
3. On [Start] display, select [Diagnosis].
4. On [Select Vehicle] display, input the target vehicle information and select [Set].
5. On [Main Menu] display, select [Each System].
6. On [Select System] display, select [Brake Control], and then select [Enter].
7. On [Select Function] display, select [Work Support].
8. On [Work Support] display, select [Selection of Parameter].
Check the applied model and option code indicated on the "Model number plate". Ref. to IDENTIFICATION .
Enter the applied model of 7-digit alphanumeric characters and click the [OK] button.
When the option code input screen appears after entering the applied model, enter the option code consisting of 4-digit alphanumeric characters, and click the [OK] button. When the option code is 3 digits, add "0" (zero) in front and enter the code as 4 digits.
When the confirmation screen indicating the vehicle information appears, check that the correct applied model and grade are displayed and click the [OK] button.
NOTE: When the displayed applied model and grade are different from those of the vehicle, click the [OK] button and then perform the registration operation again.
Execute the Clear Memory Mode after parameter selection and registration operations because the DTC for "Parameter selection error" is memorized.