Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2018 >> Forester 2.5i, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control/Fuel Injection System (H4DOTC)) >> Knock Sensor >> Installation >> RH Side

RH Side

WARNING: This page is about a different variant/trim than selected.
  1. Install the knock sensor to the cylinder block.
    NOTE: The knock sensor should be installed so that the center of the connector is positioned at a 32.5 - 47.5° angle relative to the rear of engine.

    Tightening torque: 

    24 N.m (2.4 kgf-m, 17.7 ft-lb)

    G12509004Courtesy of SUBARU OF AMERICA, INC.
  2. Connect the connector to the knock sensor.
    G12509005Courtesy of SUBARU OF AMERICA, INC.
  3. Install the fuel pipe insulator No. 3. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>Fuel Insulator>INSTALLATION>FUEL PIPE INSULATOR NO. 3 .
  4. Install the intake manifold. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>Intake Manifold>INSTALLATION .
  5. Connect the battery ground terminal.
  6. Install the collector cover.
scientia non olet · About Mike's Workshop Manuals