Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2018 >> Forester 2.5i, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control/Fuel Injection System (H4DOTC)) >> Engine Coolant Temperature Sensor >> Removal

Engine Coolant Temperature Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the collector cover.
    1. Remove the clip (A).
    2. Hold the shaded area (B) by hand and carefully pull the RH side (C) upward.
    3. Hold the shaded area (D) by hand and carefully pull the LH side (E) upward.
    G12508974Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the ground cable from battery.
  3. Drain engine coolant. Ref. to COOLING (H4DOTC)>Engine Coolant>REPLACEMENT>DRAINING OF ENGINE COOLANT .
  4. Disconnect the connector (A) from the engine coolant temperature sensor, and remove the engine coolant temperature sensor.
    G12508975Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals