Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Subaru >> 2018 >> Forester 2.5i, Standard Trans >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Function Setting (Customize) >> Procedure >> Stopping Keyless Access System Function By Door Open/Close Procedure

Stopping Keyless Access System Function By Door Open/Close Procedure

  1. Check that the vehicle status is as follows:
    • Ignition switch OFF
    • One window is completely open
    • Keyless access system is activated (or disabled if re-activating)
  2. Sit in the driver's seat with the door closed and press the door lock switch to UNLOCK once.
  3. Open the driver's door within five seconds.
  4. Within 5 seconds, with the driver's door opened, slowly press the door lock switch to UNLOCK twice.
  5. Within 10 seconds after finishing step  4, perform the closing → opening operation of the driver's door twice.
  6. Within 10 seconds after finishing step  5, with the driver's door opened, slowly press the door lock switch to UNLOCK twice.
  7. Within 10 seconds after finishing step  6, perform the closing → opening operation of the driver's door once.
  8. Within 5 seconds after finishing step  7, close the driver's door.
    NOTE:
    • Perform the same procedures to re-activate the keyless access system from the disabled condition.
    • On step  4 and step  6, be sure to press the door lock switch. If pressing interval of the switch is short, the function may not stop.
scientia non olet · About Mike's Workshop Manuals